1. wire diameter:3mm or 4mm
2. high tensile strength 1770Mpa
3. mesh size:103mm x 180mm
4. Mesh shape:diamond
5. Material:high tensile steel wire
rockfall Mesh Specification:
Mesh shape: diamond
Material: high tensible carbon steel
Wire strength: 1770Mpa
Wire diameter: 3mm
Corrosion protection: super coating
Mesh opening: 103mm x 180mm
Breaking load of single wire: 12.5KN
Tensile strength: 110KN/m
1. Convenience and flexiblity for installation along the landscape.
2. The low cost is good for mass usage.
3. It provides a 15 year guarantee.
4. The fence is a versatile and easily erected form of fencing.
5. The products with galvanized and aluminum coated treatment have a good looking and performance of rust
6. A further advantage is transparent performance.As the open
weave, chain link fences do not obscure sunlight so you can enjoy
the bright view. One also can make a chain link fence semi-opaque
by inserting slats into the mesh.
rockfall mesh standard roll:
Mesh edges knotted
Roll width: 1m - 3.5m
Roll length:10m or 30m
Hole size: G80 or G65
2. Easy to install
3. Don't need maintenance
4) TECCO mesh:
The TECCO system consists of four main components that are
carefully coordinated with each other:
1). TECCO steel wire mesh
TECCO mesh is made of high-tensile steel wire with an ultimate
tensile strength of >1770 N/mm2.
2). TECCO spike plates
Rigid spike plates that are reinforced with ribbing ensure optimal
load transmission from soil or rock
anchors to the TECCO mesh.
These plates are placed over the anchor heads and tightened to
pre-tension the mesh onto the slope.
The plates are galvanized and have dimensions of
3). TECCO connection clips
The connection clips high-strength steel wire connection clips
enable mesh sections to be joined without
overlapping and still guarantee one hundred percent transfer of
These claw are hot dip galvanized and consist of 0.25"(6mm) thick
4). Soil or rock nails
Adapted to the local soil and rock static requirements,
the TECCO mesh can be anchored in accordance with our dimensioning
concept with commercial soil or
The main anchors of the system are installed in a grid typically
from 6.6 to 13.1 ft (2.0 to 4.0m)horizontal and
vertical spacing.Actual spacing depends upon the results of site
analysis and modeling.
Anchor consist of commercially available steel bars ranging from
1.0 to 1.25 ft (25 to 32mm).
Selfdrilling grout injection anchors are also permitted.Additional
anchors may also be used to
provide added support at boundaries and in low points and hollows.